[email protected] | +44 7776 800169
AMS Logo

CAT Seals & Gaskets

Genuine & OEM Seals & Gaskets Parts

CAT Seals & Gaskets Parts

Seals and gaskets prevent oil, coolant, fuel and combustion gases escaping between mating surfaces throughout the engine, and almost every joint opened during a repair depends on one. This group covers head gaskets, manifold and cover gaskets, front and rear crankshaft seals, valve stem seals, O-rings and toric seals, and complete upper and lower gasket sets. CAT engines in generator, marine and industrial service run long hours at sustained load, which works sealing faces hard and makes head gasket condition a common finding at overhaul. On the larger 3500 and C175 platforms, individual cylinder heads mean gaskets are replaced per cylinder rather than as a single large item, which changes both the parts list and the job.

AMS Parts supplies a wide range of seals & gaskets components for CAT engines used in power generation, marine, and industrial applications. Browse the full range below, or contact us for specific requirements.

Frequently Asked Questions

Are gasket sets available for individual cylinders on larger CAT engines?

Yes. The 3500 series and C175 use individual cylinder heads, so head gaskets and seals are supplied per cylinder rather than as one full-width gasket.

What causes head gasket failure on a CAT engine?

Overheating, a distorted or corroded sealing face, incorrect bolt torque or sequence, and sustained overload are the usual causes. The gasket is normally the symptom rather than the root cause.

Should a full gasket set be used for a top-end job?

An upper gasket set covers head and manifold work. A full set is only needed when the engine is split, so specify which level of overhaul is planned when ordering.